Configure Approver

Article summary

Did you find this summary helpful?

Thank you for your feedback

You can configure the Approver on the APPROVER CONFIGURATION pop-up page.

To configure Approver, perform the following steps:

Select Asset > Configuration > Others > Deactivation Approval Matrix.
The DEACTIVATION APPROVAL MATRIX page is displayed.
On the ACTIONS panel of the DEACTIVATION APPROVAL MATRIX page, click CONFIGURE APPROVER. The CONFIGURE APPROVER pop-up page is displayed.

Figure: APPROVER CONFIGURATION pop-up page
On the CONFIGURE APPROVER pop-up page, specify all the required information. To know more about the fields available on the CONFIGURE APPROVER pop-up page, see the Field Description section.
Click SUBMIT.

The following table describes the fields on the CONFIGURE APPROVER pop-up page:

Field	Description
Tenant	Select a Tenant from the drop-down list.
Master Type Value	Select a value from the drop-down list. The type of the Approver is configured on the COMMON MASTER TYPE page. The Master Type Value is configured on the COMMON MASTER page.
Approver	Type in and select the name of the Approver.
Active	If selected, this configuration becomes active.

Was this article helpful?

Table of contents